Napoleon Fireplaces GDI30 Manuel d'utilisateur télécharger pdf (Page 18)

W415-0806 / 06.28.09

8.0 MAINTENANCE

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper

and dangerous operation. Verify proper operation after servicing. This ﬁ replace and its venting system

should be inspected before use and at least annually by a qualiﬁ ed service person. The ﬁ replace area must

be kept clear and free of combustible materials, gasoline or other ﬂ ammable vapors and liquids. The ﬂ ow of

combustion and ventilation air must not be obstructed.

1. In order to properly clean the burner and pilot assembly, remove the logs, rocks and/or glass to

expose both assemblies.

2. Keep the control compartment, media, burner, air shutter opening and the area surrounding the logs

clean by vacuuming or brushing, at least once a year.

3. Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or

are not burning properly.

4. Check to see that the pilot ﬂ ame is large enough to engulf the ﬂ ame sensor and/or thermocouple /

thermopile as well as reaches the burner.

5. Replace the cleaned logs, rocks or glass. Failure to properly position the media may cause carboning

which can be distributed in the surrounding living area.

6. Check to see that the main burner ignites completely on all openings when turned on. A 5 to 10

second total light-up period is satisfactory. If ignition takes longer, consult your local authorized dealer /

distributor.

7. Check that the gasketing on the sides, top and bottom of the door is not broken or missing. Replace if

necessary.

8. If for any reason the vent air intake system is disassembled, re-install and re-seal per the instructions

provided for the initial installation.

40.1

MAINTENANCE

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.

WARNING

It’s important to periodically perform a visual check of the pilot and burner

ﬂ ames. Compare them to the illustrations provided. If any ﬂ ames appear

abnormal call a service person.

54.2

3/8” - 1/2”

FLAME MUST

ENVELOPE UPPER

3/8" TO 1/2" OF

THERMOCOUPLE &

THERMOPILE

7.4 FLAME CHARACTERISTICS

Turn counter-

clockwise to

decrease ﬂ ame

height

Turn clockwise

to increase ﬂ ame

height

FLAME ADJUSTMENT KNOB

7.3 FLAME ADJUSTMENT

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Commentaires sur ces manuels

Pas de commentaire

Napoleon Fireplaces GDI30 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Napoleon Fireplaces GDI30