Napoleon Fireplaces GDI30 Manuel d'utilisateur télécharger pdf (Page 14)

W415-0806 / 06.28.09

4.4.3 Position the front right log just behind the

grate lining up the holes in the bottom with

the studs located on the log support.

4.4.4 Move the left log into position lining up the

hole in the bottom with the stud on the left

side of the log support.

4.4.5 Line up the square hole in the right crossover

with the square post located on the right side

of log and install as shown.

4.4.6 Line up the rectangular hole in the left cross-

over with the rectangular post located on the

left side of log and install as shown.

Remove the backing of the logo supplied and place on the glass viewing door, as

indicated.

½"

LOGO

4.5 OPTIONAL CHARCOAL EMBERS

4.7 LOGO PLACEMENT

4.6 GLOWING EMBERS

Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of

the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed

edges of the ﬁ bre hairs will glow. The ember material will only glow when exposed to direct ﬂ ame; how-

ever, care should be taken to not block the burner ports.

Blocked burner ports can cause an incorrect ﬂ ame pattern, carbon deposits and delayed ignition. PHAZER

logs glow when exposed to direct ﬂ ame. Use only certiﬁ ed "glowing embers" and PHAZER

logs available

from your authorized dealer / distributor.

32.1

Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.

Fine dust found in the bottom of the bag should not be used.

NOTE: Charcoal embers are not to be placed on the burner.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Pas de commentaire

Napoleon Fireplaces GDI30 Manuel d'utilisateur Page 14